44
Service Manual
Removal:
1. Remove the free arm extension table, bed bottom cover, extension table bottom cover,
arm top cover, right side cover, the buttonhole assembly (see pages 63-64) and the
hand wheel (see pages 21-22).
2. Remove screw nut ( I ) and the eccentric screw (H).
3. Position the top of the eccentric gear(C) at the back of the machine
4. Turn shaft (E) counterclockwise until stitch regulator stroke (B) is in the vertical position
and keep it in that position
5. Remove the spring (A) and fork (B) by pushing it down
Replacement:
1. Replacement is the same as removal in reverse order.
2. Adjust feed dog throw.(See pages 105-106)
Feed forked connection
P/N 358426002
MAR/05
Rev. no.
To Previous Page
Loading...
