Introduction – 3
English
Introduction – 3
English
Overview Accessories
Included Accessories (Not Pictured)
• Needles
• Foot control
• Power cord
• Extension Table
Bobbin x4 — Only use the type of metal bobbins delivered with your machine (SINGER® Class 15 met-
al bobbins). One of the bobbins is inserted in the machine upon delivery.
Felt Pad x2 — Used to cushion the spool of thread when using the Auxiliary Spool Pin.
Spool Cap — Two sizes (one large and one small) for various thread spool styles.
Auxiliary Spool Pin — For sewing with large thread spools or when using specialty threads.
Brush and Seam Ripper — Used to remove stitches/brush o lint.
Screwdriver — Used to remove the needle plate, presser foot holder or needle screw.
Edge/Quilting Guide — Used for straight and accurate sewing, e.g., when quilting. Insert the guide into
the slot at the back of the presser foot holder. Adjust the position to t your project.
Presser Feet
All Purpose Foot
(attached to the machine upon delivery)
This foot is used for general sewing on most types of fabric. The bottom of the foot is at, so that the fabric
is held down rmly against the feed teeth while sewing. It also has a wide slot so that the needle can move
from left to right, depending on which stitch you sew.
Zipper Foot (I)
This foot is used for inserting zippers. Attach the foot to the presser foot holder on either side of the foot,
depending on which side of the zipper is being sewn. The Zipper Foot can also be used to create and insert
piping.
To Next Page
Loading...
