Why is my Singer Expert Finish II not producing steam?
If your Singer Iron is not producing steam or not enough steam, the water tank may be low or empty, so add water. Also, ensure that the iron is set to the steam setting. For maximum steam, the temperature should be on MAX ••• 200º C.
What to do if my Singer Expert Finish II Iron is dripping water?
If your Singer Iron is dripping water from the steam vents, it could be due to a few reasons. First, check if you've overfilled the water tank; do not fill past the MAX line. Also, the iron might not be hot enough, so set the temperature to MAX ••• 200º C. Finally, excessive use of the Burst of Steam function can cause dripping, so allow more time between bursts.
How to fix a Singer Iron that won't heat up?
If your Singer Iron does not heat up, make sure it is properly plugged in. Also, check that the temperature setting is not too low; increase it to a higher setting. It's also possible that the Auto-Off feature has been activated; move or shake the iron gently to deactivate it.
Why is my Singer Expert Finish II Iron emitting odor?
If your Singer Iron is emitting small particles or an odor, this is usually normal. Follow the instructions for first-time use. It may also indicate that the water needs to be changed. A buildup of mineral deposits inside the steam chamber could also be the cause, so refer to the “Self-Cleaning” section.
Steps for initial setup and preparing the iron for its first operation.
Instructions for safely filling the iron's water reservoir.
Procedure for powering the iron on and safely turning it off.
Guide to setting the correct temperature for various fabric types.
Instructions for performing dry ironing and steam ironing.
General| Type | Steam iron |
|---|---|
| Cord length | - m |
| Swivel angle | 360 ° |
| Product color | Blue, White |
| Soleplate type | Stainless Steel soleplate |
| Variable steam | Yes |
| Removable water tank | No |
| Steam boost function | - |
| Steam boost performance | - g/min |
| Iron power | 1700 W |
To Next Page
