45
DARNING STITCH
3.5~7.0
1.5~2.0
D
B-29
B-30
1 Select pattern 29 or 30 from the Group
Patterns "B" to get the darning stitch.
Change the presser foot to the buttonhole
foot.
1
2 Baste the upper fabric and the
reinforcement fabric together. Select the
width of the pattern by using the stitch width
button. Lower the presser foot over the
center of the tear.
3. Pull the button holder to rear. Set the button
guide plate on buttonhole foot to the
desired length.
4. The size of the darning cycle is variable.
However, the maximum stitch length is
2.6cm (1 inch) and the maximum stitch
width is 7mm (9/32 inch).
a. The length of darning pattern.
b. The width of darning pattern.
4
Start
a
b
StopStop
a
Start
b
2
3
4
1
NOTE
Make no
gap here
3
2
To Next Page
Loading...
