6
ENGLISH
INSTALLATION
Install the unit in hard & fl at fl oor, keep the room ventilated. Leave at least 20cm
space around the unit (when the hose is not connected).
1. Push the rubber adaptor of the water pipe on the drainage port of rear
panel. Please refer the following picture.
2. Connect the water pipe to bathroom, outdoor or a container, such as buck-
et.
NOTE:
1. Do not block the drainage port or water pipe.
2. Do not fold the water pipe or make it 1.5m higher than the bottom of unit.
3. Do not replace the rubber adaptor of the water pipe, it’s the special acces-
sory for the unit only, other adaptor may not fi t the unit. If it’s damaged or
lost, please call the customer service for replacement.
To Next Page
Loading...
