-7-
B: If you have both cold and hot water supplied, connect the inlet hose
by cold to cold and hot to hot.
2. Unscrew the lid of hot water connector in
water mixing valve, and then connect the
other end of water inlet hoses to the
connectors in water mixing valve by
turning the connecting nut.
RUBBER RING
SEAL
CONNECTING
NUT
Be sure a rubber ring is inside the
connecting nut.
WATER
INLET HOSE
CONNECTING
NUT
SPECIAL TOOL
COLD WATER
CONNECTOR
HOT WATER
CONNECTOR
To prevent water leakage, please ensure the connecting nut is tightened
securely.
Use special tool (enclosed with the packaging) to tighten the connecting
nut by screwing clock-wise, until the hose connector does not rotate at
joint of the connecting nut.
IMPORTANT:
Dismantling the hose directly may cause water to splash since the water pressure is still high, even
after the faucet has been turn off, so please take off the hose according to the following steps:
1) Turn off the water tap.
2) Turn on the power and keep the machine in operation.
3) Turn off the power after approximately 5 seconds.
4) Loosen the nuts on both sides of inlet hose.
CONNECTING
NUT
WATER
INLET HOSE
CONNECTING
NUT
SPECIAL TOOL
COLD WATER
CONNECTOR
HOT WATER
CONNECTOR
If the machine is used frequently, it is unnecessary to take off the
inlet hoses to avoid damage to the nut at the elbow.
1. Connect the water inlet hose to the
connector by turning the connecting
nut.
Dismantling the inlet hose
INSTALLATION
To Next Page
