Singer SIWM7000 - Drain Hose Connection; Water Supply Requirements

-5-
INSTALLATION
Water Temperature
Cold :
Recommended cold water temperature is 10~23.8℃.
Hot :
Recommended hot water temperature is 50~60℃.
Warm:
Mixture of hot and cold water. (Warm water temperature is dependent upon the water
temperature and the pressure of both the hot and cold water supply lines.)
IMPORTANT:
Owner should turn off water supply whenever there will be an extended period of non-use.
Water Pressure
Do not operate the washer when the water pressure is lower than 0.05MPa or higher than
0.5MPa to avoid damage of the inlet system.
Water supply requirements
Change the direction of the drain hose
Unfasten the fixed screw of
the drain hose joint.
Lead out the drain hose from
the opening to the other side.
Fasten up the screw to fix
the drain hose.
Connection of the drain hose
0.7m~1.2m
Insert the end of the drain hose into the hook shelf,
and hang the drain hose over a drain outlet (bath tub,
sink, etc.).
Note: The highest point of the drain hose must be in
the height of 0.7m~1.2m above floor level,
otherwise, the washer can not work normally.
Connection of the drain hose