8
ENGLISH
3. Take out the water tank and fi ll it with water (Fig. 1 & Fig. 2).
4. The max capacity of water tank is 1,8L, the water level shall not exceed
the MAX mark.
Steam ironing
1. We recommend you fi lling water tank (A) before steam ironing.
2. Connect the plug to the wall outlet, press down the On/Off Power switch
(H).
3. The power light will illuminate. Turn temperature switch to your desired
setting, which is depended on the fabric of garment (Fig.3). Then the
heating indicator will illuminate (Fig. 4). Refer to IRONING TIPS
TEMPERATURE ADJUSTMENT
POSITION
TYPE OF FABRIC STEAM
● Nylon, silk, synthetic fi bers NO
ECO ECO YES (weak)
●● Wool YES
●●● Cotton YES
MAX Linen YES
TURBO Linen YES (strong)
SELF CLEAN / YES
Off /NO
Anti-drip system: result no water runs at temperature settings below ECO, where no
steam is emitted.
4. Wait until the heating indicator light (F) goes out; it indicates the soleplate
temperature has reached the selected temperature.
5. Open lock B and take out the iron.
6. According to your requirement, you can select the desired steam output
for each garment. Make sure that there is enough water in the tank.When
pressing steam button (D) for the fi rst time, a little water may drip from the
soleplate due to initial thermal instability.
7. To obtain a constant jet of steam, press the steam button (D) or lock
steam control (C) (Fig. 5).
8. The appliance will then be ready to start ironing. The steam ready light
(G) (Fig.4) will then switch on and off automatically as the steam is used.
Slight noise will also sometimes be heard, which is caused by the pump
refi lling the water tank. Continue ironing normally.
To Next Page