SINTERIT Lisa X - Printer Usage Safety Guidelines

Sinterit LISA PRO User Manual | 7
IMPORTANT!
Add a little more powder than ts in the Feed Bed.
IMPORTANT!
The information which powder to use has been displayed on the printer screen as well as in the
Sinterit Studio software end report.
6. Compress the powder using the metal spatula provided in Dedicated Powder Tools. This will release any residual air
trapped in the Feed Bed during the pouring of the powder. Afterwards press DONE.
7. Remove any powder spilled directly under the guide bars. You may use the brushes and spatulas provided in
Dedicated Powder Tools. Afterwards press DONE.
8. Choose START LEVELING to begin leveling the powder surface.
IMPORTANT!
During the powder leveling process you can scrape the excess powder from under the guides with
a plastic spatula, for example from the Dedicated Powder Tools set.
9. You should see a smooth powder surface in the print chamber. Once the surface is suciently level, choose STOP
LEVELING.
10. Press DONE to advance to the following step.
2.4 PREPARING THE PRINT CHAMBER
1. Delicately wipe the pyrometer window with a wipe soaked in 2% salicylic spirits (ethanol solution) or another ethanol-
based cleaning solution. You may also use cleaning wipes provided in Dedicated Powder Tools.
2. Wipe the pyrometer window again with a dry cotton cloth, in order to remove any alcohol residue. Afterwards press
DONE.
3. Wipe the recoater guide bar with a wipe soaked in 2% salicylic spirits (ethanol solution) or another ethanol-based
cleaning solution. You may also use cleaning wipes provided in Dedicated Powder Tools.
4. Wipe the recoater guide bar again with a dry cotton cloth, in order to remove any alcohol residue. Afterwards press
DONE.
5. Apply silicone oil (available in Dedicated Powder Tools) to the recoater guide bar. A few drops along the whole length
is enough. Afterwards press DONE.
6. Make sure no miscellaneous items (i.e. spatulas) remain in the print chamber, then close the lid. Afterwards press
DONE.
2.5 FINAL STEPS BEFORE PRINTING
1. Press the RESET button on the printer itself, in order to engage the safety mechanism.
2. Choose START PRINT to begin printing.