3 INFORMATION FOR TYPE APPROVAL
Figure 3.3: Preamplifier and capsule
Next, insert the TA 202L (C) dry adapter between the components that are currently separated (figure 3.4).
Check whether the black sealing ring of the dry adapter is still correctly located on the thread root.
NOTICE! Without the dry adapter Tango_Plus must not be operated with the weather
protection!
Figure 3.4: TA202L mounting between preamplifier and capsule
Next, prepare the weather protection for the assembly. First remove the Windscreen (D) (figure 3.5).
Figure 3.5: Weather protector and windscreen
Then unscrew the Protective Sleeve (E) from the Shaft (G) and loosen the Shank Head (F) slightly. Be
sure to use strength only on the stainless steel components and not damage the fee. Then turn off the
socket (H) (figure 3.6).
Figure 3.6: Disassembling of the Weather protector SWS1
Pass the Tango_Plus microphone cable (I) through the shaft, so that the socket end can be connected
to the composite microphone unit on the preamplifier. At the end of the shaft, guide the cable through the
recess before screwing the socket (H) back in (figure 3.7).
Manual Tango_Plus 30 of 47 SINUS Messtechnik GmbH
To Next Page
Loading...
