6
CAUTION: The warnings and cautions mentioned in this user manual can not cov-
er all possible conditions and situations that may occur. It must be understood by
the operator that common sense and caution are factors which cannot be built
into this product, but must be applied.
When using the sander always ensure the operator as well as those in the
area wear eye protection.
Sanding operations will cause dust to become airborne with the potential to be
highly toxic; always wear a face mask during these operations, as well as ensuring
the area is well ventilated. It is also highly recommended to use a dust collector to
reduce airborne particles.
When using this sander, it is advisable to ensure the operator as well as
those in the area wear ear protection, particularly during extended periods
of use.
Safety Symbols Used Throughout This Manual.
Danger / Caution: Indicates risk of personal injury and/or the possibility of
damage.
Warning: Risk of electrical injury or damage!
Note: Supplementary information.
Operational Safety.
SAFETY INSTRUCTIONS….cont
23
35 Pin 5×10 WD01-00035
36 Screw M5×25 WD01-00036
37 Belt tracking knob WD01-00037
38 Flat washer M6 WD01-00038
39 Rubber washer WD01-00039
40 Adjust spring WD01-00040
41 Belt frame WD01-00041
42 Tension spring WD01-00042
43 Sleeve WD01-00043
44 Spring washer M12 WD01-00044
45 Bearing 6001RZ WD01-00045
46 Idler shaft WD01-00046
47 Idler pulley WD01-00047
48 Belt tension assembly WD01-00048
49 Hex screw M6×12 WD01-00049
50 Belt working table WD01-00050
51 Big washer M6 WD01-00051
52 Miter gauge Knob WD01-00052
53 Sanding belt 120 grit 07740
53 Sanding belt 60 grit 07744
54 Drive pulley WD01-00053
55 Hex screw M8×12 WD01-00054
56 Collector shaft WD01-00055
57 Screw M5×8 WD01-00056
58 Flat washer M5 WD01-00057
59 Work table angle point WD01-00058
60 Belt frame connect WD01-00059
61 Cord bushing WD01-00060
62 Belt cover WD01-00061
63 Pin 2x10 WD01-00062
64 Spring washer WD01-00063
65 Connection plate WD01-00064
66 Right cover WD01-00065
67 Left cover WD01-00066
68 Small pulley WD01-00067
To Next Page
Loading...
General