17
4 Clean the surface with the alcohol preparation pad and let it dry
thoroughly.
5 Peel off the adhesive liner. Position,
press, and hold the Dash Mount and
PowerConnect Vehicle Dock in place for
30 seconds.
IMPORTANT! Allow the Dash Mount adhesive
to cure (dry) for a minimum of 2-4 hours before using the mount. The best
adhesion occurs after 24 hours.
6 The dock mounting plate can be tilted in different directions.
Adjust as necessary for your particular vehicle. When the
orientation is correct, tighten the knob.
TIP! To remove, carefully lift the adhesive pad with your fingers or a spoon.
Warming the pad with a hair dryer for several minutes will help soften the
adhesive.
Knob Adhesive Foot Dock Mounting
Plate
To Next Page
Loading...
Need help?
General
