2
These Notes Must Be Read Before Installation
This appliance is an Inset Live Fuel Effect appliance that provides radiant or
combined radiant and convected heat; it cannot and should not be used as the
main heating source within a property.
The appliance is designed to fit most types of fireplaces with a natural draught flue
as listed in the Installation Requirements.
The appliance must be installed by a competent person in accordance with the Gas
Safety (Installation and Use) Regulations 1998.
A Gas Safety Registered installer must be used for this purpose.
Read all these instructions before any installation takes place and in conjunction
with the appliance on site.
This appliance must be installed in accordance with the rules in force and only used
in a sufficiently ventilated space.
This appliance is factory set and tested for operation on the gas type, and at the
pressure stated on the appliance data plate.
After a new gas appliance (excluding flueless cookers) has been fitted, the Building
Regulations in England and Wales require that the installation must be notified to
your Local Authority. Your Gas safe registered engineer needs to do this, failure to
register the appliance may affect your warranty.
To Next Page
Loading...