What to do if the Sirona Diagnostic Equipment has problems with the Processor(s)?
If you're experiencing issues with the processor(s) on your Sirona Diagnostic Equipment, a possible solution is to replace the PC.
What to do if Sirona Diagnostic Equipment fails the Test SM Bus?
If the SM Bus Test is failing on your Sirona Diagnostic Equipment, consider replacing the PC.
What to do if Sirona Diagnostic Equipment fails the Test DMA #1?
If the DMA #1 Test is failing on your Sirona Diagnostic Equipment, you may need to replace the PC.
What to do if Sirona Diagnostic Equipment fails the Test INT #1?
If the INT #1 Test is failing on your Sirona Diagnostic Equipment, the suggested solution is to replace the PC.
What to do if Sirona Diagnostic Equipment fails the Test Keyboard Controller?
If the Keyboard Controller Test is failing on your Sirona Diagnostic Equipment, the suggested solution is to replace the PC.
What to do if Sirona Diagnostic Equipment fails the Test Timer?
If the Timer Test is failing on your Sirona Diagnostic Equipment, a possible solution is to replace the PC.
What to do if Sirona Diagnostic Equipment fails the Test CPU-1?
If the CPU-1 Test is failing on your Sirona Diagnostic Equipment, consider replacing the PC.
What to do if Sirona Diagnostic Equipment fails the Test NET #1 Self-Test?
If the NET #1 Self-Test is failing on your Sirona Diagnostic Equipment, you may need to replace the PC.
What to do if Sirona Diagnostic Equipment fails the Test Active?
If the Active Test is failing on your Sirona Diagnostic Equipment, the suggested solution is to replace the PC.
What to do if the Sirona Diagnostic Equipment fails the Stress Test Drive?
If you are experiencing issues with the Stress Test Drive on your Sirona Diagnostic Equipment, try the following: 1. Check the SATA cable of the hard drive. 2. Check the cable of the hard drive power supply. 3. Replace the hard drive including the hard drive cable.
Covers prerequisites, connection, general safety, and unit stability for safe operation. Includes danger levels and connection procedures.
Describes the CAD system, camera, and monitor components, listing specifications like resolution and measuring technique.
Lists detailed technical specifications including voltage, current, operating conditions, dimensions, and weight.
Outlines EMC compliance and guidelines for electromagnetic emissions and immunity, with specific test levels.
Covers initial setup, controls, LEDs, connections, and powering on the unit.
Step-by-step guide for performing optical impressions using the Omnicam, including safety notes and handling.
Guidance on camera positioning for different scanning sequences like occlusal, buccal, lingual, and approximal scans.
Provides instructions and lists approved agents for cleaning and disinfecting the unit and its components, including monitor and surfaces.
Detailed steps for calibrating the CEREC Omnicam to ensure accurate measurement procedures, including when recalibration is needed.
Explains how to perform color calibration for accurate color analysis and when it's necessary, including storage and replacement of the calibration set.
Instructions on how to start the PC diagnostic tool and select tests like Customer or Technician Diagnostics from the boot menu.
General| Manufacturer | Sirona Dental Systems |
|---|---|
| Model | CEREC AC |
| Software | CEREC Software |
| Light Source | LED |
| Application | Dental impressions |
| Imaging Technology | Optical |
| Dimensions | Varies depending on configuration (scanning unit, acquisition center) |
| Weight | Varies depending on configuration |
| Scanning Principle | Optical Scanning |
To Next Page
