This manual is the property of SISER S.r.l., any even partial reproduction is forbidden
Mod. PRD 20/3 - Last updating 10/2019
TS-One Manual for use and maintenance
34
3.3 Safety Measures, Symbols and Warning Mechanisms of the Machine
Hazardous parts of the machine are protected within the limits imposed by the needs of use.
The electrical parts are protected to avoid direct contact, as they are enclosed inside the
machine body and control panel. The wires are equipped with suitable insulation.
to protect against indirect contact.
transmits to the top of the housing and not just the intended lower platen on which the fabric
The caution and danger symbols shown above indicate the presence of residual hazards which,
due to the type of machine, were not possible to eliminate.
PPE: personal protective equipment
During use and maintenance of the machine, heat-resistant gloves must be worn to avoid burns
burns are:
• lower stand, upper heating platen, protective screen on the upper heating plating, fastening
TS
ONE
3
EN
Protective screen
Heating Plate
ON/OFF
switch
To Next Page
Loading...
