This manual is the property of SISER S.r.l., any even partial reproduction is forbidden
Mod. PRD 20/3 - Last updating 10/2019
TS-One Manual for use and maintenance
35
3.4 Hazards and Safety Measures
The hazardous parts in use on the machine are outlined in the following table, together with the
Physical contact with
the platen
Switch off the machine and wait 2 hours before
changing or touching the platens.
Caution: despite insulation on the heating
elements, the heat is transmitted to the upper
platen cover; avoid direct contact during use.
Wear heat-resistant gloves.
Contact of the platen
materials
Do not apply heat transfer materials to
combustible liquids or gas.
materials near the machine.
Closure of the platen
during closure to prevent possible crushing.
the machine.
Hazard Danger zone/phase Safety Measures
TS
ONE
3
Burns
Fire
Crushing hands
Electrocution
EN
rating plate of the machine.
necessary. Protect the cords and power panels from moisture.
Unplug the machine before performing any maintenance. Authorize expert
exposed, in particular in passage areas; they can cause tripping or get
damaged.
parts. Do not touch electrical components with wet hands. Do not tamper
use insulating tape for joints, but only replace the cords.
To Next Page
Loading...
