This manual is the property of SISER S.r.l., any even partial reproduction is forbidden
Mod. PRD 20/3 - Last updating 10/2019
TS-One Manual for use and maintenance
45
TS
ONE
6
EN
6 MAINTENANCE
Any non-compliance with the following safety instructions can cause serious danger to people
and/or severe damage to the machine.
Any maintenance and/or repairs must only be carried out after positioning the
switch on zero, unplugging the machine from the electrical power supply and
with the heating elements at room temperature.
After switching off the machine, wait two hours to allow the platens to cool
before intervention.
Each time before
switch on
Each time before
switch on
Each time before
switch on
Each time before
switch on
use.
If the cord or plug are not suitable, do no proceed to
switch on and contact the retailer.
platen each time before use.
In case of wear, do not proceed to switch on and
contact the retailer.
the upper platen each time before use.
In case of wear, do not proceed to switch on and
contact the retailer.
Lubricate with oil suitable for the materials to use.
If the handle is worn, contact the retailer.
Proceed to remove dust and dirt from the control
in water.
Maintenance Frequency Procedure/Corrective actions
and cord
platen rubber
platen
protection
handle unit
Press cleaning
To Next Page
Loading...
