This manual is the property of SISER S.r.l., any even partial reproduction is forbidden
Mod. PRD 20/3 - Last updating 10/2019
TS-One Manual for use and maintenance
46
TS
ONE
6
EN
proceed, if necessary, to remove dust and dirt that can invalidate correct use.
6.1 Errors
6.2 Replacement of the Heating Element and Thermocouple
Remove the top cover of the heating platen; you can then access the thermocouple and the
heating element.
Only use original SISER heating elements and thermocouples supplied by SISER S.r.l.
6.3 Replacement of Fuses F1 and F2
To replace the fuses, open the control panel after the machine is electrically isolated, removing
The fuses are located on the electronic circuit board.
Be cautious to replace the damaged fuse out of use with one of equal voltage
• Problem with thyristor: the press does not heat or heats beyond
the temperature set.
• If the problem persists, contact Siser
support.
• Problem with temperature probe: it can indicate no reading of the
temperature or board.
• If the problem persists, contact Siser support.
• If the control has a positive outcome, reconnect the plug and
• If the problem persists, contact Siser support.
Type of error Procedure/Corrective actions
000
111
La pressa non
si accende
To Next Page
Loading...
