Sit 610 AC3 - Operation Guide; Ignition and Burner Operation; Shutdown Procedure

Ignition
Depress and turn the control knob to the pilot posi-
tion .
Depress the button and ignite the pilot flame while
keeping the knob fully depressed for a few seconds
(fig. 1).
Release the knob and check that the pilot flame stays
lit. If it goes out, repeat the ignition operation.
Main burner ignition
Depress and turn the control knob to the position
corresponding to symbol . On release, the knob
returns to the ON position . Turn the temperature
selection knob to the point corresponding to the
desired temperature (fig. 3).
Pilot position
To close the main burner and keep the pilot flame on,
depress and turn the control knob to the pilot posi-
tion (fig. 1).
Shutdown
Turn the control knob to the OFF position (fig. 4).
CAUTION: after shutting down, wait at least two
minutes before re-igniting so as to allow the flame
failure device to return to the safety position.
OPERATION
fig. 4
fig. 1
fig. 2
fig. 3