8
Main gas connection
G3/4 version (external thread)
-
Connection with gasket (A)
Use gas pipes with a suitable flat annular surface to allow the use of a sealing gasket.
The locking ring thread shall comply with ISO 228.
Ensure the gasket is suitable for the use.
Apply the proper torque to the locking ring, according to the washer characteristics, in order to ensure the seal.
WARNING:
do not over-tighten the locking ring.
-
Connection with union joint (B)
Use SIT joint 0.982.001.
Ensure the locking ring is properly engaged.
Recommended torque range 40-60 Nm.
Do not overtorque.
To Next Page
Loading...
