What to do if my SIVIK STD-7330 lift does not work?
If your SIVIK Lifting Systems lift isn't working, possible causes include: no power (check and restore power if necessary), disconnected electrical wires (reconnect them), blown fuses (replace them), or a faulty maximum height limit switch (check the switch and its connection, replacing if needed).
Why SIVIK STD-7330 Lifting Systems lift does not raise?
If your SIVIK Lifting Systems lift isn't raising, the issue could stem from several causes: incorrect motor rotation (interchange the two phases on the main switch), insufficient hydraulic oil (add some), air in the hydraulic circuit (bleed the system), a faulty UP button (check the button and its connection, replacing if needed), a faulty maximum pressure valve (check, clean, or replace), a stuck lowering solenoid valve (check, clean, or replace), an unclosed emergency screw on the lowering solenoid valve (retighten the screw), a dirty pump filter (check and clean), or a blown pump suction (check the seal and replace if needed).
What to do if SIVIK STD-7330 lift does not lower when pressing the DOWN button?
If your SIVIK Lifting Systems lift isn't lowering when you press the DOWN button, the problem could be a faulty lowering solenoid valve (verify if it's powered and check the magneto for damage, replacing if needed), a faulty DOWN button (check and replace if necessary), or insufficient compressed air pressure (adjust the air pressure).
Why SIVIK STD-7330 motor does not stop at maximum height?
If the motor of your SIVIK Lifting Systems lift doesn't stop when reaching its maximum height, it's likely that the maximum height limit switch is not working. Check the limit switch and replace it if needed.
How to fix SIVIK STD-7330 lift that does not lift or lower smoothly?
If your SIVIK Lifting Systems lift doesn't lift or lower smoothly, it could be due to leakages or air in the hydraulic circuit (bleed the hydraulic system), a dirty pump filter (check and clean if needed), or a blown pump suction (check the seal and replace if needed).
What causes platforms to be not leveled on SIVIK STD-7330?
If the platforms of your SIVIK Lifting Systems are not leveled, this may be caused by oil leakages in the hydraulic circuit. Check the circuit for any leakage.
General| Brand | SIVIK |
|---|---|
| Model | STD-7330 |
| Category | Lifting Systems |
| Language | English |
To Next Page