18
WPUA800C / WPUA800F
CAUTION
•
Do not disassemble the product at your own discretion.
–
Doing so may result in fire or electric shock.
•
Be sure to use genuine SK Magic components (filters/fittings/tubing) and ask a professional
engineer to replace them.
–
Failure to do so may result in product failure or reduce the product life.
Direct and Cold
Water Pipe
Cold Water
Supply
Valve
Ambient Temperature
Water Supply Valve
Source Water
Supply Valve
NOS Valve
Pressure
Reduction
Valve
Flow Sensor
Source Water
Supply Valve
90°
Step 1
Sediment
Step 2
Block
Carbon
Composite
Step 3
Nanotech
PAC
NOTE
When the product is installed or any filter is
replaced, each filter should be cleaned.
•
Based on the initial filter cleaning, let the
water flow for about 10 minutes (based on
the water flow of 20 L at about 1 kg/cm
2
water pressure).
According to the nature of each filter, bubbles
or dark water may come out. However, this
only happens during the first cleaning and
does not affect the purification performance.
White Coloring of Purified Water
•
For direct water purification products, this is
a temporary scenario that may occur due to
micro bubbles that form during water output.
The micro bubbles will disappear naturally
and they do not affect the water quality. If the
water purified by this product is boiled, white
sediment may appear. These are not foreign
materials, but are the mineral sediments.
Source
water
Purified
water
To Next Page
Loading...