Skeeter DEEP-V - Livewell;Baitwell System Settings

3-18Table Of Contents www.SkeeterBoats.com
DEEP-V BOATS
FILL: Turn the remote valve control to the CLOSE
position. Use the “FILL” switch at the control panel
to start the pump. Turn the pump off when the well is
at the correct level.
RECIRCULATE: Use the “RECIRC” switch at the
control panel to recirculate and aerate the water in
the well to maintain sufcient oxygen for sh/bait.
Your boat may be equipped with a timer that can be
set to automatically recirculate at desired intervals.
EMPTY: Turn the remote valve control to the OPEN
position to empty.
Rinse the livewell and baitwell (if equipped) with
fresh clean water, remove any debris from the pick-
up and drain screens, and allow the livewell to air-
dry after each use. The pick-up screens are located
at the bottom of the transom and the drain screens
are located in the livewell or baitwell.
LIVEWELL/BAITWEL SYSTEM SETTINGS
Your Skeeter boat is equipped with a livewell/baitwell system designed to your keep sh alive and
healthy.
Optional Equipment
Your Skeeter boat may be equipped with many options which cannot all be covered in this manual.
Make sure you read and understand the optional equipment’s safety, use, and maintenance literature
provided by the manufacturer to maximize the benets and uses these options have to offer. Contact
your Skeeter Dealer for more information or explanation.
Figure 3-17
Figure 3-18