10 EN
Place the drive unit on top of the full grease
cannister and make sure the teeth of both
parts are engaged.
The spindle head should now be inside of the
motor coupler.
Screw the drive unit cap onto the cannister.
If the support flange is not mounted on the
application, screw the complete lubricator
onto the application. Your lubricator is ready.
If the support flange is mounted already
on the application, the use of sealing tape
(PTFE) on the thread of the new cannister tip
is recommended.
Then screw the cartridge on the support
flange mounted in the application.
Your lubricator is ready.
To Next Page
Loading...
Need help?
General
