93
1. 1.Position 1 (not numbered)
Each number modifies maximum engine RPM by about 200 RPM.
Lower numbers decrease engine RPM in steps of 200 RPM and
higher numbers increase it in steps of 200 RPM.
Example:
Calibration screw is set at position 4 and is changed to position 6.
So maximum engine RPM is increased of 400 RPM.
To adjust:
Just loosen locking nut enough to pull calibration screw partially out
and adjust to desired position. Do not completely remove the locking
nut. Torque locking nuts to 10 N•m (89 lbf•in).
-
CAUTION
Do not completely remove calibration screw or its inside
washer will fall off. Always adjust all 3 calibration screws and
make sure they are all set at the same number.
A16D0GA
1
To Next Page