However, to completely drain the sys-
tem, blow into the tank through the
vent tube while blocking the tank filler
neck with one hand to prevent air
leakage.
...
CAUTION: To prevent rust for-
..
mation in the cooling system, al-
ways replenish the system with the re-
commended solution (60% anti-freeze
40% water).
To refill the cooling system:
Remove engine filler plug.
Refill tank until coolant overfills at
filler hole.
Reinstall filler plug.
20
O
NOTE: Always maintain a certain
coolant level in the tank while
performing this procedure.
Continue to pour the liquid in the
coolant tank until level reaches 2.5 mm
(1") below filler neck.
Reinstall tank cap and start engine; let
engine run until it reaches its operating
temperature and thermostat opens.
Al-
low it to run a few minutes more Stop
engine and check coolant level, refill as
necessary.
....
WARNING:
Before removing the
~
cap place a cloth over the coolant
tank and release the cap to the first
step to release the pressure. Loss of
fluid and possibility of severe burns
could occur, if this notice is disre-
garded.
Track
Inspect the track for wear, cuts, miss-
ing track guides and broken rods.
Make any necessary replacement.
.....
WARNING:
Do not operate a
~
snowmobile with a cut, torn or
damage track.
Lift the rear of vehicle -rntil track is
clear of the ground then support
with
a
brace or trestle. The snowmobile
should be stored in such a way that the
track does not
Jtay in contact with the
cement floor or bare ground.
O
NOTE: The track should be rotat-
ed periodically, (every 40 days).
Do not release track tension.
tIP
CAUTION: To prevent track
...
damage, temperature in the stor-
age area must not exceed
38°C
(100°F).
Slide Suspension
Remove any dirt or rust. Replace worn
slider shoes.
To Next Page