NOTE: Apply wax on glossy finish only. Protect the vehicle with a
cover to prevent dust accumulation during storage.
CAUTION: The snowmobile has to be stored on a cool and dry
place and covered with an opaque tarpaulin. This will prevent
sun rays and grime from affecting plastic components and vehi-
cle finish.
Lift rear of vehicle until track is clear of the ground, Install on a wide-
base snowmobile mechanical stand.
NOTE: Do not release track tension.
Bulb Replacement
Always check light operation after bulb replacement.
Headlamp
Find which bulb is burnt, then replace it with a new one (P/N 415 128
619).
Unplug electrical connector then, turn bulb counterclockwise to re-
move it.
1
A31E0WA
1. Electrical connector
If damaged, the headlamp harness can be replaced with a new one
(P/N 415 128 618).
86
_________________________
To Next Page
Loading...
