Squeeze firmly
AOOS
006 002
After the adjustment,
brake
should apply
fully when
lever
is
approximately 13 mm
(
112
in) from handlebar grip. If
not
do
not tamper with the
brake,
contact your
servicing dealer.
13
mm
(112
in)
A008
006
002
Spark
Plugs
Disconnect the spark plug wires and re-
move the spark plugs.
Check the condition
of
the plugs.
• A brownish tip reflects ideal condi-
tions. (Carburetor adjustments, spark
plug heat range, etc., are correct).
• A black insulator tip indicates foul-
ing caused by: carburetor idle speed
mixture and/or high speed mixture
too rich, incorrect fuel mixture ratio,
wrong type of
spark
plug
(heat
range),
or excessive idling.
• A light grey insulator tip indicates a
lean mixture caused by: carburetor
high speed mixture adjusted too
lean, wrong spark plug heat range,
incorrect fuel mixture ratio, or a leak-
ing
seal
or
32
________________________
__
AOOO
004
010
Normal
(brownish)
Fouled
(black)
,.,.
CAUTION: If spark plug condition
T
is
not ideal,
contact
your autho-
rized dealer.
Check spark plug gap using a wire feel-
er
gauge, adjust to 0.4 mm (.016 in).
Reinstall plugs and connect wires.
Suspension
Condition
Check
all
front suspension components
for excessive play or wear including ball
joints, control arms and links etc.
Visually inspect
all
rear
suspension com-
ponents including slider shoes, springs,
wheels, etc.
0
NOTE: During normal driving,
snow will act
as
a lubricant and
coolant for the slider shoes. Extensive
riding on ice or sanded snow will create
excessive heat build-up and cause pre-
mature slider shoe wear.
Suspension
Adjustments
The rear suspension has three adjust-
ments:
- The front shock spring for surface
condition.
- The rear shock spring (twin shocks)
for driver's weight.
- Limiter screw to control weight trans-
fer during acceleration.
To Next Page
Loading...
