Skil AG242001 - Troubleshooting Common Issues; Tool Start-up Problems; Tool Speed Issues

19
TROUBLE SHOOTING
Problem Cause Remedy
Tool will not start 1. The power cord is not
plugged in.
2. The power source fuse or
circuit breaker tripped.
3. The cord damaged.
4. Burned out switch.
1. Plug the tool into a power source.
2. Replace the fuse or reset the
tripped circuit breaker. (If the
product repeatedly causes
the circuit or fuse to trip/blow,
discontinue use immediately and
have it serviced by an Authorized
SKIL Service Center or Service
Station.)
3. Inspect the cord for damage. If
damaged, have the cord replaced
by an Authorized SKIL Service
Center or Service Station.
4. Have switch replaced by an
Authorized SKIL Service Center
or Service Station.
Tool does not come
up to speed
1. Extension cord has
insufcient gauge or is too
long.
2. Low house voltage.
1. Replace with an adequate
extension cord (Refer to the part
of “EXTENSION CORDS”).
2. Contact your electric company.