SKMEI (Model 1077) DIGITAL WATCH INSTRUCTIONS
Four buttons on this watch are known as: LIGHT, MODE, RESET, and START
TO SELECT THE DISPLAY MODE
Push the Mode Button to select one of the following four display modes in the following order:
Normal Time -> Stop Watch -> Alarm Set -> Time Set
In the Normal Time Mode, the Day of Week, the Hour, Minute and Second are displayed (none
flash). If the alarm bell icon at the bottom left is displayed, the alarm is turned on.
TO STOP/START THE ALARM
Press the MODE button x 2 to view the current alarm set time.
Press the START button to toggle between alarm on and hourly chime on, and off.
The small bell icon indicates the alarm is on.
The small triangle indicates the hourly chime is on.
TO SET THE TIME & DATE
Press the MODE button x 3 until the seconds are flashing.
To set the Hour press the RESET button x 1. Press the START button to increase the hours.
When an H is shown the watch is set in 24 hour time mode.
Press the RESET button again to toggle through Minutes -> Month -> Date -> Day of Week ->
Seconds
Press the START button to change the setting you are on.
Press the MODE button to complete.
To Next Page
Need help?
General
