Note
All information in the memory 1 and 2 is erased if the battery of the vehicle is dis-
connected.
Ð
Operation
Fig. 7
Multifunction display: Control el-
ements
First read and observe the introductory information and safety warn-
ings on page 11.
The rocker switch
A
and the button
B
are located on the windscreen wiper lev-
er » Fig. 7.
Select memory
›
Press the button
B
» Fig. 7.
Selecting functions
›
Briefly press the rocker switch
A
» Fig. 7 up or down. This opens the individual
functions of the multifunction display one after the other.
Resetting
›
Select the desired memory.
›
Press the button
B
» Fig. 7 for longer.
The following readouts of the selected memory will be set to zero by button
B
:
›
Average fuel consumption
›
Distance driven
›
Average speed
›
Driving time
Ð
ä
Digital clock
First read and observe the introductory information and safety warn-
ings on page 11.
The time is set as follows:
›
Press the rocker switch
A
» Fig. 7 on page 12 up or down to change the display
of the time.
›
Press the button
6
» Fig. 3 on page 8 to select the hour display so that it
flashes.
›
Press button
3
to continue setting the time. Keep the button pressed to run
through the numbers quickly.
›
Press the button
6
to select the minutes display so that it flashes.
›
Press button
3
to continue setting the time. Keep the button pressed to run
through the numbers quickly.
›
Confirm the set value by pressing the button
6
again, or wait for around 5 sec-
onds. The setting is saved automatically (the value stops flashing).
Ð
Multifunction display details
First read and observe the introductory information and safety warn-
ings on page 11.
Outside temperature
The current outside temperature is shown in the display.
If the outside temperature drops below +4 °C, the temperature indicator appears
and a snow flake symbol (black ice warning) flashes for a few seconds, then re-
mains displayed together with the outside temperature.
Driving time
The driving time which has elapsed since the memory was last erased, appears in
the display » page 11. If you want to measure the driving time from a particular
moment in time on, at this moment, reset the memory by setting the button
B
» Fig. 7 on page 12 to zero.
The maximum distance indicated in both memories is 19 hours and 59 minutes.
The indicator is set back to zero if this period is exceeded.
£
ä
ä
12
Using the system
To Next Page
Loading...
