Activating/deactivating
Fig. 102
Operating lever: Cruise control
system controls
First read and observe the introductory information and safety warn-
ings on page 114.
Activating
›
Move switch
A
» Fig. 102 into the ON position.
Deactivating
›
Move switch
A
» Fig. 102 into the OFF position.
Storing and maintaining speed
First read and observe the introductory information and safety warn-
ings on page 114.
›
Activate the cruise control system » page 115.
›
Drive at the desired speed.
›
Push the rocker button
B
into the SET/- » Fig. 102 on page 115 position.
After you have released the rocker button
B
from the SET/- position, the speed
you have just stored is kept constant without having to depress the accelerator.
Changing the stored speed
First read and observe the introductory information and safety warn-
ings
on page 114.
Increasing the speed with the rocker button
B
›
Push the rocker button
B
into the RES/+ » Fig. 102 on page 115 position.
If the rocker button is held in the RES/+ position, the speed will increase continu-
ously. Release the rocker button once the desired speed is reached. The set
speed is then stored in the memory.
Decreasing the speed using the rocker button
B
The stored speed can be reduced by pushing the rocker switch
B
into the
SET/- » Fig. 102 on page 115 position.
If the rocker button is pressed and held in the SET/- position, the speed will de-
crease continuously. Release the rocker button once the desired speed is
reached. The set speed is then stored in the memory.
If the rocker button is released at a speed of less than approx. 25 km/h, the speed
is not stored and the memory is erased. Once the speed of the vehicle has in-
creased to more than approx. 25 km/h, the speed must then be stored again by
pushing the rocker button
B
into the SET/- position.
Increasing the speed with the accelerator
›
Depress the accelerator pedal.
Releasing the accelerator pedal will cause the speed to drop again to the set
speed.
Decreasing the speed with the brake pedal
The speed can also be reduced by depressing the brake pedal, which temporarily
deactivates the system » page 115.
Switching off temporarily
First read and observe the introductory information and safety warn-
ings
on page 114.
The cruise control system can be temporarily deactivated by pushing the switch
A
» Fig. 102 on page 115 into the spring-mounted CANCEL position or by depress-
ing the brake or clutch pedal.
The set speed remains stored in the memory.
Briefly push the rocker button
B
into the RES/+ position in order to resume the
stored speed after the clutch or brake pedal is released.
115
Assist systems
To Next Page
Loading...
