›
To filter the stations according to programme type (e.g. culture, music, sport
etc.) in the FM
1)
and DAB
2)
station list, tap on the function surface --
» Fig. 164 - .
Information symbols
Symbol Meaning
Radio station, which is stored on a preset button
Currently played stations
Traffic information station
(e.g.)
Type of program being broadcast (FM) (does not apply to Info-
tainment Swing)
(e.g.) Type the regional broadcast (FM)
(e.g.)
Type of program being broadcast (FM, DAB) (applies to the info-
tainment Swing)
Signal reception is not available (DAB)
The transmitter reception is not secure (DAB) (applies to Info-
tainment Amundsen, Bolero, Swing)
Stations with image broadcasting (DAB) (does not apply to info-
tainment Swing)
Refresh list
Depending on Infotainment, the station list update takes place as follows:
Frequen-
cy
Columbus Amundsen, Bolero Swing
FM automatically automatically automatically
AM automatically manually manually
DAB automatically manually manually
▶
To manually update, tap on the function surface » Fig. 164 .
CAUTION
To sort the stations according to genre, the RDS and AF functions must be
switched on. These functions can be set in the radio main menu in the FM band
by tapping the function surface →
Advanced settings
switched on / off.
Preset buttons for your favourite channels
In every broadcasting range, there are station buttons available to store pre-
ferred stations
C
That are split into groups
E
» Fig. 163 on page 139 or .
›
To save a station on the main menu Radio, hold down the desired function
surface
C
until an acoustic signal sounds.
›
To save a station in the station list, keep the function surface of the desired
station held down, select the memory group, and then tap the desired station
button.
If a station is saved on an already assigned station button, this station button
will be overwritten.
Station logos - Columbus, Amundsen, Bolero
Station logos are stored in the Infotainment memory which are assigned auto-
matically by the device when storing the stations under preset buttons.
Assign station logo automatically
›
to Disable / Enable in the radio main menu, tap on the function surface
Tap on→
Advanced settings
→
Auto-save station logos
.
Assign station logo manually
›
Tap on the function surface in the Radio main menu
→
Station logos
.
›
Tap on an occupied station button and select the data carrier (SD card, USB).
›
Search for and select the desired station logo on the respective data carrier.
Remove channel logo manually
›
Tap on the function surface in the Radio main menu
→
Station logos
.
›
Tap on the station button from which you want to remove a logo.
Note
■
The following image formats are supported: jpg, gif, png, bmp.
■
We recommend a resolution of up to 500x500 pixels.
Station logos - Swing
The station button of a preferred station can contain the name and the station
logo.
1)
Applies when the RDS function is switched on.
2)
Applies during selected global sorting of the station list.
141
Radio
To Next Page
Loading...
