Range selector key SETUP10
Range selector key SETUP
Tone settings
By pressing the button and pressing on the function key in the RADIO
mode, you can select the following parameters using the menu control button :
• - , ,
and - Volume when switching
on, volume of incoming traffic announcements, volume of navigation announce-
ments and speed dependent volume adjustment;
• - Treble setting;
• - Midtone setting;
• - Bass setting;
• - Setting of the volume ratio between the left and right side;
• - Setting of the volume ratio between the front and the rear;
• * - Setting the equalizer (linear, language, rock, classical, dance);
• * - setting of the surround tone.
GALA function
Your radio increases automatically its volume with the increasing vehicle speed. A
higher setting value results in a stronger volume increase.
Note
You can set the tone parameters using the menu control button or the function
keys or .
System settings
Press the button and select the function key .
You can select between the following parameters:
• - Menu language for the displays and the language messages;
• - Keypad display for text entry;
• * - if your vehicle is equipped with climatronic, the setting
change is displayed when it is activated;
• - Setting the brightness of the screen;
• - Factory settings;
• - the information regarding the complete memory capacity of
the SD card and the size of the memory assigned to the navigation data is displayed
on the screen;
• - Removing the SD card.
Radio set-ups
Press the button in the RADIO mode.
Switching the traffic announcements on or off
– If you wish to switch the reception of traffic reports on or off, press the
function key .
Determining the station selection via the
– By pressing on or , you can select the source
from which the stations are to be selected while in the RADIO mode
using the arrow keys. If the is selected, only stored
stations from the memory list are called up. The symbol “
@ ” is
displayed on the screen.
Switching the RDS function on or off (RDS regional)
– Press on the function key (regional station) and select a
set-up in the opening pop-up window.
SETUP To ne