Range selector key NAV (Navigation)30
• The number of useable and tracked satellites to be received (the number of
useable satellites determines the GPS status).
Delete destinations in the destinations memory or in the list of
the last destinations
– Press the button while in a random menu of the Navigation.
– You can select the function key using the
menu control button .
– In the pop-up window, you can delete all manually or automatically
stored destinations or only the last destinations using the function
keys or .
Store or edit your home address
Storing the current position as a home address
– Press on the function key while in the main menu Navi-
gation.
– If your home address has not yet been stored, confirm the following
question with the function key .
– Press on the function key and your current position is stored
as home address.
Editing a stored home address
– If your home address has already been stored, the automatic route
guidance starts after pressing the function key .
– If you wish to change your home address, press the button and
then the menu point while in the menu
Navigation.
Route guidance
Entering a stopover destination
If, in addition to the displayed travel destination, a stopover destination is
added, proceed as follows. The stopover destination can only be entered
when starting the route guidance.
– Select the destination and start the route guidance.
– Press on the range selector key to change into the main menu
Navigation.
– Select a destination and start the route guidance.
– If you wish to store the newly entered destination as a stopover desti-
nation, press the function key .
– If you wish to end the route guidance which has started, press the
function key .
Only one destination and one stopover destination can be entered during the route
guidance.
A corresponding navigation announcement sounds when reaching the stopover
destination. The route guidance is renewed after a few seconds. Then you can re-
enter a new stopover destination.
If you enter a new stopover destination before reaching the original destination,
you must decide if you wish to overwrite the “old” stopover destination with the
“new” stopover destination.
Route options
The menu Route options is used to determine the criteria according to
which a route is to be calculated and what types of destinations you wish
to allow for the route calculation. The route options can also be changed
during a route guidance.
SETUP
Delete destinations memory
To Next Page
Loading...
Need help?
General
