Unlocking and locking 57
Using the system Safety Driving Tips General Maintenance Breakdown assistance Technical Data
Panoramic sliding roof* (Combi)
Introduction
The panoramic sliding roof with sun screen can only be operated with the control dial
when the ignition is switched on fig. 43. The control dial has several positions.
After switching off the ignition, it is still possible to open, close and tilt the panoramic
sliding roof or the sun screen for approx. 10 minutes. However, it is no longer possible
to operate the panoramic sliding roof and the sun screen the moment you open one
of the front doors.
Opening and tilting the panoramic sliding roof
Comfort position
– Turn the switch to position page 57, fig. 43.
Open partially
– Turn the switch to a position in area .
Open fully
– Turn the switch to position and hold it in this position (spring-tensioned posi-
tion).
Tilting and closing
– In order to tilt, press the switch on the recess in the direction of the roof.
– In order to close, press down the switch on the recess and then push it forwards.
When the panoramic sliding roof is in the comfort position, the intensity of the wind
noise is reduced.
It may be necessary during winter to remove any ice and snow in the area of the pano-
ramic sliding roof before opening it, in order to prevent damaging the opening
mechanism.
Closing the panoramic sliding roof
Closing
– Turn the switch to position page 57, fig. 43.
Force limiter
The panoramic sliding roof is fitted with a force limiter. The panoramic sliding roof
stops and moves back several centimetres when it cannot be closed because there is
something in the way (e.g. ice). You can close the panoramic sliding roof fully without
force limiter by pressing down the switch on the recess and then pushing it forwards
until the panoramic sliding roof is fully closed .
To Next Page
Loading...
