Seats and Stowage 95
Using the system Safety Driving Tips General Maintenance Breakdown assistance Technical Data
Tensioning strap
– Insert the holder of the tensioning strap into the opening of the left or right carrier
rail.
– Press the holder in direction of arrow fig. 91 and push it at the same time in
the desired position, arrow .
– Ensure that the holder is correctly interlocked.
– Place the object which should be fastened behind the tensioning strap.
– Press the button on the top side of the holder and tighten the strap.
The objects in the luggage compartment must be firmly secured with the fixing
set so that they cannot move freely and uncontrollably in order to prevent
damage to objects or injuries to the occupants.
Do not use the fixing set for securing objects which might damage the fixing set.
The tensioning strap can also be fully reeled up by pressing the button
fig. 91.
Moveable lashing eyes* (Combi)
Fig. 92 Moveable lashing eyes
Four moveable lashing eyes, which can be used for example for attaching the fixing
net, are located in the luggage compartment.
– Press the button page 95, fig. 92 and push the lashing eye in the desired
position, arrow .
– Fold up the clamp page 95, fig. 92 and fix, for example, the fixing net.
Net partition* (Combi)
Use the net partition behind the rear seats
Pulling out
– Pull the net partition at the bracket fig. 93 out of the housing in direction
of the holders .
– Insert the cross rod into one of the mounts and push the cross rod forwards.
– In the same way, fix the cross rod to the other side of the vehicle, mount .
Folding
– Pull the cross rod back slightly, first on the one side then on the other side and take
the cross rod out of the mounts fig. 93.
– Hold the cross rod in such a way that the net partition can roll up into the housing
slowly and without damage.
To Next Page
Loading...
