SKS Germany COMPIT - Page 24

GERMANY
Mounting the COMPIT on the Handlebars of the Bicycle and Removing it
24
A non-uniform tightening of the screws when mounting the COMPIT on the bicycle
can result in the COMPIT becoming detached from the bicycle and causing injuries.
➤When mounting the COMPIT, tighten the screws alternately and uniformly.
CAUTION
!
!
➤ Use a torque spanner to mount the COMPIT on the handlebars of the bicycle. To do so, tighten the screws
(4) alternately and uniformly applying the torque that is stated on the clamping arms (2 Nm).
Remove the COMPIT from the handlebars of the bicycle as follows:
➤ Loosen the screws.
➤ Remove the COMPIT from the handlebars of the bicycle together with the clamping arms.