sks 300098 - Resetting

SKS-Kinkel Elektronik GmbH
EN
300098 BUS bell
Support-Hotline: +49 (0) 2661 98088 112
- 20 -
Version: 1.1
E-Mail: support@sks-kinkel.de
Dokument Art. No. 97010601
6 Resetting
To reset to the factory setting it is necessary to follow the steps below:
Step
Description
1
Pull off the a+/b- terminal on the back of the indoor station.
2
Press the programming button (Prog.) on the back of the indoor station and keep it pressed.
3
Plug in the a+/b- terminal again.
4
After a few seconds, an acknowledgment tone sounds, indicating that the operation was successful.
Once the 300098 BUS bell has been reset to factory setting, all settings are deleted and have to be made again.
7 Technical data
Electric data
Voltage a+/b-
19 – 23 VDC
General
Ambient Temperature
-10°C up to +45°C
Humidity
20% up to 90% not condensing
Housing
Plastic housing
Dimensions (width x height x depth)
90 x 212 x 23 mm
Type
IP20