The Dual Intake Kit is used when you are venting 2 kilns that are each under 12 Cubic Feet or When you are vent-
ing a single kiln between 12 and 24 Cubic Feet. The kit contains the following items.:
Two 8 ft. x 3” Flexible Aluminum Duct
One Spring Loaded Plenum Cup Assembly
The Extension Kit is used when you need additional ducting than what is provided with a standard Envirovent 2.
The kit contains the following items:
One 8 ft. x 3” Flexible Aluminum Duct
The EnviroLink is an accessory item that can be ordered for the EnviroVent
and Envirovent 2 that works in conjunction with the Skutt KilnMaster or
GlassMaster controller. It allows you to program the controller to automatically
turn the vent on and off throughout a fi ring program. You simply enter an on/off
setting for each segment of a Ramp and Hold program while you are programming
the kiln. There are preset “vent programs” that can be run in conjunction with a
ConeFire Mode program as well.
To Next Page
Loading...
