Skutt 1027 - Custom Installations; Dual Intake Kit; Venting 2 Kilns

9
CUSTOM INSTALLATIONS
DUAL INTAKE KIT
A Dual Intake Kit is required when you are venting 2 kilns with one Envirovent 2 or a single kiln that
is greater than 12 cubic feet in volume.
Dual Intake Kit Contents
A Dual Intake Kit contains : an additional Spring Loaded Plenum Cup Assembly, 4 - Hose Clamps, 1- 3” Y Duct
Connector and 2 - 8’ x 3” Flexible Aluminum Duct Sections.
3" Di
a
Tube
Flex
Clamps
Radiator
Y-Duct
Connector
Envirovent
2
2-Kiln Installatio
n
Aluminum
Cup Stan
d
With Spring
Radiator
Clam
p
Cu
p
Aluminum
Cup Stan
d
With Spring
Radiator
Clam
Clam
p
Flex
Tub
e
3" Di
a
Installation for Two Kilns
Follow the instructions for installing the EnviroVent 2. The only difference will be that the 3” ducting from the
Plenum Cup Assemblies of the two units will attach to a Y-Duct connector and then up to the motor. See above
diagram.
VENTING 2 KILNS