Skutt 1027 - Specifications; Service; Reference

15
Specifi cations
Motor: 115 volt
1.4 amps
50/60 Hz
Heat exiting blower: 160 °F maximum
Blower: 140 cfm
Maximum kiln capacity for use with EnviroVent 2: 12 cubic feet (24 cubic feet with dual intake kit)
SPECIFICATIONS
Service
If your EnviroVent 2 requires service, contact your dealer, distributor or Skutt Ceramic Products, Inc. Warranty
information can be found on the warranty card included with your Envirovent 2.
Reference
The EnviroVent 2 is a UL listed accessory when used with the following Skutt UL listed kilns.
Models
Voltage
Voltage
Phase
1227-3 240 or 208 volt
1227-3 240 or 208 volt 3 phase
1027-3 240 or 208 volt
1027-3 240 or 208 volt 3 phase
1027 240 or 208 volt
1027 240 or 208 volt 3 phase
1018-3 240 or 208 volt
1018 240 or 208 volt
818-3 240 or 208 volt
818 240 or 208 volt
NOTE: All of the above kilns may have a prefi x of KM or KS.
KS818P-3 240 or 208 volt
KS818P 240 or 208 volt
KM818-30A-3 240 or 208 volt
KM1218-3 240 or 208 volt
KM1218-3 240 or 208 volt 3 phase
KM1627-3-PK 240 or 208 volt 3 phase
KM1627-3-PK-LF 240 or 208 volt
KM1627-3-PK-LF 240 or 208 volt 3 phase
KM1231-3-PK 240 or 208 volt
KM1231-3-PK 240 or 208 volt 3 phase
KM1227-3-PK 240 or 208 volt
KM1227-3-PK 240 or 208 volt 3 phase
Models
Voltage
Voltage
Phase
GM1227-3 240 or 208 volt
GM1227-3 240 or 208 volt 3 phase
GM1018 240 or 208 volt
GM818 240 or 208 volt
GM1414 240 or 208 volt
GM1414 240 or 208 volt 3 phase
GM1014 240 or 208 volt
GM814 240 or 208 volt
GM22CS 240 or 208 volt
GM22CS 240 or 208 volt 3 phase