20
X. Toggle video boost
Using the Video Boost will enable you to increase the Video Power setting by 1 power level, without having
to go into the dedicated menu. When active, a ‘’V’’ will appear on top of your GCS screen, indicating your
device is now flying with the boosted value. Deactivating the Video Boost will revert the video power setting
back to the original value. This boost will not be affected by your compliance setting.
XI. Toggle angle boost
For each device you can select a max angle boost. When used, an ‘’S’’ for Speed will appear on top of your
GCS screen, indicating your device is now flying with the boosted value of your max tilt angle. This is very
useful when you need to be able to quickly increase the max speed of the UAV.
By default, this value is set to 15 degrees and non boosted value to 9 degrees. This setting can be further
adjusted please refer to «ADVANCED SETTINGS USER MANUAL».
XII. Toggle drone sleep
This function allows to put the current connected device into a sleep mode, generating a lower power drain
and increasing the device’s battery lifetime. No audio-video signal is emitted and all LED are turned off. You
can recover normal operation by reconnecting to the drone (by pressing the corresponding device button)
or by toggling the function again. Your GCS remains fully functional.
XIII. Toggle push-to-talk
This function enables the use of one the GCS’ Allocatable Button as a PTT. The use of a dedicate cable for
your radio system might be necessary. Please contact our customer service for detailed information : sup-
port@sky-hero.com
XIV. Motor shutdown
Also called as emergency shutdown, this function will immediately cut all four motors, regardless of the
UAV’s current situation or position, leading to instant UAV crash down. This can be used if the UAV starts to
exhibit abnormal flight behaviour and cannot be recovered by the operator.
After this emergency, the UAV can be flown again by pressing takeoff landing (B1) but it is recommended to
first proceed to a closer mechanical inspection after the crash of the UAV.
To Next Page
