11
Countering Drift & Setting Trim
Even after the quadcopter is calibrated, it may show a tendency to drift while airborne.
Adjusting the trim will counter this effect and allow the unit to hover in place. Adjust
the trim while flying as controlled and low to the ground as possible.
Remember, the red propeller blades indicate the front of the quadcopter.
If the trim adjustments do not seem to be helping, or seem to be making the problem
worse, press the Reset button to the right of the Left Control Stick, to reset the trim
to factory default settings and try again.
Quadcopter yaws/spins left or right.
Drift Type
Trim settings continued on the following page.
Solution
Press L/R buttons under the
Left Control Stick.
Front
Trim Adjustment
To Next Page