14 15
Access control panel
How can I access my Sky Hub’s control panel?
You can control a variety of settings in your Sky Hub’s
control panel such as changing your network name
and password.
To log into the control panel via your internet browser
on a device connected to your Sky Hub:
• In the address bar of your browser type http://192.168.0.1/
• The username is admin
• The password is sky unless you changed it
Resetting your Sky Hub
How do I reset to factory settings?
Ensure your Sky Hub is plugged in at the mains and
switched on. Then, press and hold the reset button
on the back of the device until the power light begins
to flash green. This can take up to 10 seconds.
Don’t unplug or switch off your Sky Hub while it resets.
The power light will flash amber then will return to solid
green when completed.
WPS
The WPS (Wi-Fi Protected Setup) button can be used to
connect other WPS-compatible devices to your Sky Hub.
How do I connect using WPS?
• Activate WPS on your WPS-compatible device
• Next, press the WPS button on your Sky Hub – the WPS
light will flash amber. If there is a successful connection,
the WPS light on your Sky Hub will go solid green, before
turning off after two minutes.
If not, or if your Sky Hub cannot find your device, the light
may flash red or turn solid amber.
All lights should be solid
green when your Sky Hub
is working properly. If any
are solid or flashing amber
or red you can find out
how to fix your Sky Hub
at sky.com/help
Understanding your Sky Hub
To Next Page
Loading...
