EasyManuals Logo

SkyBitz SMARTank ST90 User Manual

SkyBitz SMARTank ST90
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
9
The tank’s default setting is a single Callout per day between 12:00 AM and 12:59 AM. This setting is
automatically active upon installation without any further programming of the Call Settings on the
tank Setup tab.
Scheduled Callouts
There are 4 specific parameters for the scheduled Callouts that need to be programmed as indicated
below:
Start Time allows the selection of a specific time, within a 1 hour window, in which the tank will call
out the first time during that 24-hour period. The selection is made using the drop-down list box
where all the valid selections are listed. This sets the starting time or first callout from this tank for
the day.
Call Interval allows the time spacing, in hours, between subsequent Callouts from the tank. Select
the desired interval from the drop-down list-box.
Calls per Day allows the selection of the specific number of Callouts for a given day. Select the
number of Callouts using the drop-down list-box.
Day Schedule allows the selection of the specific days of the week when the Callouts should occur.
Each day of the week can be activated or deactivated by clicking on the Checkbox independent of
the others.
Note: that the selection of the first three parameters above are inter-related so that the Callouts can
occur in a single 24-hour period. Hence it is important to select the Preview Schedule which brings
up a summary of the settings made and will display an error if the selections conflict with each
other.
Preview Schedule allows one to view the programmed settings. An error warning will be displayed if
the settings conflict. It is advisable to always select this after programming or changing the four
scheduled Callout parameters above thereby eliminating any unintentional errors.
Call On % Change
Call On % Change allows the Callout based on a % inventory change, increase or decrease, regardless
of the scheduled Callouts programmed above. This Callout is not dependent on the scheduled
Callout settings above. This provides the former feature of inventory Callout based on inventory
change that was part of the scheduled Callout programming with the Jumpers.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the SkyBitz SMARTank ST90 and is the answer not in the manual?

SkyBitz SMARTank ST90 Specifications

General IconGeneral
BrandSkyBitz
ModelSMARTank ST90
CategoryMonitor
LanguageEnglish