you have a clear line of sight.
Lights
NOTE: This setting does not persist over battery swaps and
power cycles. Each time you power on your drone, you will
need to re-configure your Lights setting.
Toggle the lights on your X2 motors to display the colored
LEDs (RGB), infrared sensors, or white strobe lights:
• RGB - Toggled on by default. These are the standard LEDs
on the motors that are blue when the drone is
powered on, and red and green when in flight. You
can choose to toggle these off.
• Infrared - Infrared sensors that cannot be seen by
the naked eye. Toggle these on when needing to fly
more discreetly, and use night vision goggles to view
the infrared lights on the drone.
• Strobe - Displays a white strobe light on the motors. Helps
visually keep track of the drone, especially in
low-light conditions. Skydio X2’s strobe lights are
visible at a distance of 3 statute miles.
NOTE: You can toggle on either Strobe or Infrared lights, but
not both at the same time.
33 Skydio X2 - User guide © 2021 Skydio, Inc. All rights reserved.
DEVICE SETTINGS / DRONE SETTINGS
GPS Night Flight
NOTE: This setting does not persist over battery swaps and
power cycles. Each time you power on your drone, you will
need to re-enter GPS Night Flight mode if desired.
To Next Page
Loading...
Need help?
General
