precisely land your drone a few inches above dirt or vegetation.
To perform a case landing:
1. Position the drone about 10 ft above the case.
2. Use the gimbal control to tilt the camera down so the case and Skydio logo are clearly in view.
3. Press and hold the land button in the app or on the controller to initiate a landing. If the drone locks on to the case, a yellow
ring will circle the Skydio logo.
4. If you do not see the yellow ring, cancel the landing and try again.
NOTE: To initiate a case landing, the Skydio case must be in view of Skydio X2’s camera while it is landing. A yellow ring will appear
around the case in the live video feed to indicate that Skydio X2 has seen the case and will land on it. If you do not see the yellow ring,
Skydio X2 will not land on the case and will continue to descend straight down.
CAUTION: Piloting or nudging the vehicle during a case landing will cancel the case landing and continue with a normal
landing. Be careful not to accidentally touch the controller joysticks while X2 is performing a case landing.
NOTE: If a flight is initiated by taking off from a case (or a case is placed at Skydio X2’s exact take off point), GPS positional
accuracy cannot be relied upon to guarantee a case landing when using the Return to Home function (or in the case of a Return To
Home triggered by lost communication).
63 Skydio X2 - User guide © 2021 Skydio, Inc. All rights reserved.
POST-FLIGHT OPERATIONS
Reviewing and offloading content
Review tab
To Next Page
Loading...
Need help?
General
