manually fly the drone to a safe landing spot that is flat, clear of debris, and not overhead of any
people or animals.
Use the controller joystick to descend down to 15 ft., then
once you’re ready to land, press and hold the “LAND” button
on the screen or the controller.
Skydio X2 will descend until it is 10 ft (3 m) above the surface
below it. Once Skydio X2 is less than 10 ft from the surface,
all obstacle avoidance will be disabled for the remainder of
the landing. You will be notified of this change on screen if
flying with the Skydio Enterprise app. When in GPS Night Flight
mode, obstacle avoidance is always disabled, regardless of
Skydio X2’s height above ground.
WARNING: Skydio may recognize bushes, trees,
and similar obstacles as potential surfaces. Make
sure to first pilot the drone to an open area free of
obstacles before initiating a landing.
While Skydio X2 is landing you may nudge the drone forwards,
backward, left, or right using Controller or digital thumbsticks
in the app. Yaw control is disabled during landing. Increasing
the drone’s altitude will cancel the landing.
WARNING: Do not attempt hand-landing Skydio X2
before obstacle avoidance is disabled. Attempting
to hand-land Skydio X2 while obstacle avoidance
is active will cause it to attempt to avoid your hand
and may result in Skydio X2 impacting yourself or
another nearby object. Please review the Hand
Launching and Landing section for step-by-step
instructions and safety guidelines for this procedure.
You may also cancel any non-emergency landing by tapping
the Cancel button before the landing completes, or using the
controller to increase the drone’s altitude.
62 Skydio X2 - User guide © 2021 Skydio, Inc. All rights reserved.
LANDING
Case landing
When you are unable to find a level area to land your Skydio X2, case landing is a great way to
To Next Page
Loading...
Need help?
General
