SkyGolf Skytrak - Troubleshooting

13
Problem Soluon
When charging, ‘Power’
LED does not come on
(AMBER)
Press and hold the Power buon for 5 seconds. Make
sure the USB cable has power. Try other ports on your
computer or use a compable USB wall charger. SkyTrak
should be turned OFF to charge.
All 3 LED’s turn red and
unit turns o aer 15
seconds
Baery is low. Connect the USB cable and charge the unit.
The Power LED will turn o when SkyTrak is fully charged
and ready to go.
‘Wi-Fi’ LED is not turning
green
First, ensure that your SkyTrak is connected to the Wi-Fi
network. Then start the SkyTrak soware on your iPad and
allow it to load. When the applicaon is open, SkyTrak’s
LEDs will show whether it successfully connected.
Wi-Fi and Power LEDs
are green, but ‘Ready’
(top) LED is red
Your SkyTrak may have been triggered by a waggle
or other club movement. If you’ll wait a few seconds,
it should turn green again. If it sll doesn’t turn green,
you should check your Wi-Fi connecon and restart the
applicaon on your iPad.
Results seem inaccurate Be sure to posion the ball correctly on the red dot and
make sure the unit sits level with the hing surface. If
using a tee, make sure the base of the tee is on the red
dot.
Should this Trouble Shoong Guide not answer your queson, please refer to the
Frequently Asked Quesons at www.skytrakgolf.com .
Troubleshooting